Hydraulic Pump Troubleshooting: A Diagnostic Approach to Pressure, Flow, Noise, and Temperature

Jul 30, 2026

Leave a message

When a hydraulic pump underperforms, the instinct to immediately disassemble or replace it is almost always wrong. A systematic diagnostic approach identifies the root cause faster and prevents unnecessary component replacement.

 

Low pressure (pressure won't build up):
Start at the relief valve - check for a stuck poppet or incorrect setting. Next, inspect the suction circuit for air leaks. Only after ruling out these two should you suspect internal leakage in the pump itself. The pump is the most expensive suspect, yet statistically the least likely cause when pressure drops gradually.

Rexroth A10VSO140/32 Axial Piston Pump Extra Large Flow

Insufficient flow:
Beyond internal leakage, verify that motor speed meets specification. A slipping coupling or undersized motor reduces pump RPM and directly cuts output flow. Check the suction filter for clogging - a blocked filter creates vacuum conditions that reduce effective suction volume. Also confirm oil viscosity is within the correct range for the operating temperature. Excessively high viscosity at cold startup starves the pump inlet.

 

Excessive noise:
In most cases, noise indicates cavitation - the pump is sucking air or vapor. Inspect the suction line for loose fittings, check the filter condition, and verify oil level in the reservoir. Air ingestion through a damaged suction seal produces a characteristic whining sound that intensifies with speed. If the suction side is sound, check for aerated oil - foam in the reservoir indicates air is entering the system elsewhere.

 

Temperature rise beyond normal:
Hydraulic system temperature should remain below 65°C. Excessive heat typically originates from one of three sources: high internal leakage wasting energy as heat, incorrect oil viscosity causing excessive fluid friction, or the system failing to properly unload during standby. For variable displacement axial piston pumps, verify the control mechanism returns to near-zero displacement during idle - a stuck compensator keeps the pump at full displacement, generating heat continuously.

Send Inquiry